•
RFC 3810, Multicast Listener Discovery Version 2 (MLDv2) for IPv6
MLD configuration task list
Tasks at a glance
Configuring basic MLD
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Adjusting MLD
•
(Optional.)
•
(Optional.)
(Optional.)
Configuring MLD SSM mappings
Configuring MLD
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.)
Enabling MLD NSR
Configuring basic MLD features
Before you configure basic MLD features, complete the following tasks:
•
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices can
interoperate at the network layer.
•
Configure IPv6 PIM.
•
Determine the MLD version.
•
Determine the IPv6 multicast group address and IPv6 multicast source address for static group
member configuration.
•
Determine the ACL to be used in the IPv6 multicast group policy.
Enabling MLD
Perform this task on interfaces where IPv6 multicast group memberships are created and
maintained.
To enable MLD:
Step
1.
Enter system view.
2.
Enable IPv6 multicast
routing and enter IPv6
MRIB view.
3.
Return to system view.
4.
Enter interface view.
features:
Enabling MLD
Specifying an MLD version
Configuring a static group member
Configuring an IPv6 multicast group policy
performance:
Configuring MLD query and response parameters
Enabling fast-leave processing
proxying:
Enabling MLD proxying
Enabling IPv6 multicast forwarding on a non-querier interface
Configuring IPv6 multicast load splitting on an MLD proxy
Command
system-view
ipv6 multicast
routing [ vpn-instance vpn-instanc
e-name ]
quit
interface interface-type
interface-number
361
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
N/A
N/A