Mld Snooping Configuration Task List For Vsis - HP FlexFabric 5950 series Configuration Manual

•
(Optional.)
•
(Optional.)
Configuring the MLD snooping
•
(Optional.)
•
(Optional.)
(Optional.) Enabling MLD snooping proxying
Configuring parameters for MLD
•
(Optional.)
•
(Optional.)
Configuring MLD snooping
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)

MLD snooping configuration task list for VSIs

Tasks at a glance
Configuring basic MLD snooping
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Configuring MLD snooping port
(Optional.) Setting aging timers for dynamic ports
Configuring the MLD snooping
•
(Optional.)
•
(Optional.)
Configuring parameters for MLD
•
(Optional.)
•
(Optional.)
Configuring MLD snooping
•
(Optional.)
•
(Optional.)
For MLD reports received from secondary VLANs, the relevant MLD snooping forwarding entries are
maintained by the primary VLAN. Therefore, you need to enable MLD snooping only for the primary
VLAN. The configuration made in secondary VLANs will not take effect. For more information about
primary VLANs and secondary VLANs, see Layer 2—LAN Switching Configuration Guide.
The MLD snooping configurations made on Layer 2 aggregate interfaces do not interfere with the
configurations made on member ports. In addition, the configurations made on Layer 2 aggregate
interfaces do not take part in aggregation calculations. The configuration made on a member port of
the aggregate group takes effect after the port leaves the aggregate group.
Enabling fast-leave processing
Disabling a port from becoming a dynamic router port
querier:
Enabling the MLD snooping querier
Configuring parameters for MLD general queries and responses
messages:
Configuring source IPv6 addresses for MLD messages
Setting the 802.1p priority for MLD messages
policies:
Configuring an IPv6 multicast group policy
Enabling IPv6 multicast source port filtering
Enabling dropping unknown IPv6 multicast data
Enabling MLD report suppression
Setting the maximum number of IPv6 multicast groups on a port
Enabling IPv6 multicast group replacement
Enabling host tracking
features:
Enabling MLD snooping
Specifying an MLD snooping version
Setting the maximum number of MLD snooping forwarding entries
Setting the MLD last listener query interval
features:
querier:
Enabling the MLD snooping querier
Configuring parameters for MLD general queries and responses
messages:
Configuring source IPv6 addresses for MLD messages
Setting the 802.1p priority for MLD messages
policies:
Enabling dropping unknown IPv6 multicast data
Enabling MLD report suppression
290