Msdp Configuration Examples; Pim-Sm Inter-Domain Multicast Configuration - HP FlexFabric 5950 series Configuration Manual

Task
Display brief information about MSDP peers.
Display MSDP NSR status information.
Display detailed status of MSDP peers.
Display (S, G) entries in the SA cache.
Display the number of (S, G) entries in the SA cache.
Reset the TCP connection with an MSDP peer and
clear statistics for the MSDP peer.
Delete (S, G) entries in the SA cache.
Clear statistics for an MSDP peer without resetting
the TCP connection with the MSDP peer.

MSDP configuration examples

This section provides examples of configuring MSDP on switches.

PIM-SM inter-domain multicast configuration

Network requirements
As shown in
•
OSPF runs within AS 100 and AS 200 and BGP runs between them.
•
Each PIM-SM domain has a minimum of one multicast source or receiver.
Set up MSDP peering relationships between the RPs in the PIM-SM domains to share multicast
source information among the PIM-SM domains.
Figure 64:
Command
display
msdp [ vpn-instance vpn-instance-name ] brief
[ state { connect | disabled | established | listen
| shutdown } ]
display msdp non-stop-routing status
display
msdp [ vpn-instance vpn-instance-name ] peer-st
atus [ peer-address ]
display
msdp [ vpn-instance vpn-instance-name ] sa-cach
e [ group-address | source-address | as-number ] *
display
msdp [ vpn-instance vpn-instance-name ] sa-cou
nt [ as-number ]
reset
msdp [ vpn-instance vpn-instance-name ] peer
[ peer-address ]
reset
msdp [ vpn-instance vpn-instance-name ] sa-cach
e [ group-address ]
reset
msdp [ vpn-instance vpn-instance-name ] statistic
s [ peer-address ]
184