Bidir-Pim Configuration Example - HP FlexFabric 5950 series Configuration Manual

Elected BSR address: 10.110.9.1
Priority: 64
Hash mask length: 30
Uptime: 00:11:11
Candidate BSR address: 10.110.9.1
Priority: 64
Hash mask length: 30
# Display RP information on Switch B.
[SwitchB] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: 224.0.0.0/4
RP address
10.110.9.1
Scope: 239.0.0.0/8
Group/MaskLen: 239.0.0.0/8
RP address
10.110.1.2 (local)
# Display RP information on Switch D.
[SwitchD] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: 224.0.0.0/4
RP address
10.110.9.1
Scope: 239.0.0.0/8
Group/MaskLen: 239.0.0.0/8
RP address
10.110.5.2 (local)
# Display RP information on Switch F.
[SwitchF] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: 224.0.0.0/4
RP address
10.110.9.1 (local)

BIDIR-PIM configuration example

Network requirements
As shown in
•
OSPF runs on the network.
•
VOD streams are sent to receiver hosts in multicast.
•
Source 1 and Source 2 send multicast data to multicast group 225.1.1.1.
•
Host A and Host B are receivers of this multicast group.
•
VLAN-interface 102 of Switch C acts as the C-BSR. Loopback 0 of Switch C acts as the C-RP.
Figure 58:
Priority HoldTime
192 180
Priority HoldTime
192 180
Priority HoldTime
192 180
Priority HoldTime
192 180
Priority HoldTime
192 180
161
Uptime Expires
00:03:39 00:01:51
Uptime Expires
00:07:44 00:01:51
Uptime Expires
00:03:42 00:01:48
Uptime Expires
00:06:54 00:02:41
Uptime Expires
00:00:32 00:01:58