Last reporter: FE80::2FF:FFFF:FE00:1
Uptime: 00:00:31
Expires: 00:03:48
# Display brief information about dynamic MLD snooping group entries on Switch A.
[SwitchA] display mld-snooping group
Total 1 entries.
VLAN 100: Total 1 entries.
(::, FF1E::101)
Host ports (1 in total):
HGE1/0/3
The output shows that HundredGigE 1/0/4 (connected to Host A) has been deleted from the entry of
IPv6 multicast groups (FF1E::101).
MLD snooping configuration example (for VSIs)
Network requirements
As shown in
•
There are three sites in VPN a. They are connected through the VPLS network.
•
In VLAN 100, Source in Site 1, Host A in Site 2, and Host B in Site 3 communicate with CE 1, CE
2, and CE 3, respectively.
Configure the devices so that Host A and Host B can receive IPv6 multicast data from Source.
Figure 93 Network diagram
Source
HGE1/0/2
1::1/64
Table 23 Interface and IP address assignment
Device
PE 1
PE 1
PE 1
PE 2
PE 2
Figure
93:
VPLS network
Site 1 of VPN a
HGE1/0/1
HGE1/0/1
CE 1
VLAN 100
Interface
IP address
Vlan-int101
10.110.1.1/24
Vlan-int102
10.110.2.1/24
Loop0
1.1.1.1/32
Vlan-int101
10.110.1.2/24
Vlan-int103
10.110.3.1/24
Loop0
PE 2
Loop0
PE 1
PE 3
Loop0
Device
PE 2
PE 3
PE 3
PE 3
316
( 00:01:23 )
Site 2 of VPN a
HGE1/0/1
HGE1/0/1
CE 2
VLAN 100
Site 3 of VPN a
HGE1/0/1
HGE1/0/1
CE 3
VLAN 100
Interface
IP address
Loop0
2.2.2.2/32
Vlan-int102
10.110.2.2/24
Vlan-int103
10.110.3.2/24
Loop0
3.3.3.3/32
Receiver
HGE1/0/2
Host A
HGE1/0/2
Host B