Enabling Mld Snooping Proxying; Configuring Parameters For Mld Messages; Configuration Prerequisites - HP FlexFabric 5950 series Configuration Manual

configuration takes priority over the global configuration. For a VLAN, the VLAN-specific
configuration takes priority over the global configuration.
Configuring parameters for MLD general queries and responses globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Set the maximum response
time for MLD general
queries.
Configuring parameters for MLD general queries and responses in a VLAN or VSI
Step
1. Enter system view.
2. Enter VLAN view or VSI
view.
3. Set the MLD general query
interval in the VLAN or VSI.
4. Set the maximum response
time for MLD general queries
in the VLAN or VSI.

Enabling MLD snooping proxying

Before you enable MLD snooping proxying for a VLAN, enable MLD snooping for the VLAN.
To enable MLD snooping proxying:
Step
1. Enter system view.
2. Enter VLAN view.
3. Enable MLD snooping
proxying for the VLAN.

Configuring parameters for MLD messages

This section describes how to configure parameters for MLD messages.

Configuration prerequisites

Before you configure parameters for MLD messages, complete the following tasks:
•
Enable MLD snooping for the VLAN or VSI.
•
Determine the source IPv6 address of MLD general queries.
•
Determine the source IPv6 address of MLD multicast-address-specific queries.
Command
system-view
mld-snooping
max-response-time seconds
Command
system-view
•
Enter VLAN view:
vlan vlan-id
•
Enter VSI view:
vsi vsi-name
mld-snooping query-interval int
erval
mld-snooping
max-response-time seconds
Command
system-view
vlan vlan-id
mld-snooping proxy enable
299
Remarks
N/A
N/A
The default setting is 10 seconds.
Remarks
N/A
N/A
The default setting is 125
seconds.
The default setting is 10 seconds.
Remarks
N/A
N/A
By default, MLD snooping
proxying is disabled for a VLAN.