Configuring Source Ipv6 Addresses For Mld Messages - HP FlexFabric 5950 series Configuration Manual

•
Determine the source IPv6 address of MLD reports.
•
Determine the source IPv6 address of MLD done messages.
•
Determine the 802.1p priority of MLD messages.

Configuring source IPv6 addresses for MLD messages

You can change the source IPv6 address of the MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
You can also change the source IPv6 address of MLD reports or done messages sent by a simulated
member host or an MLD snooping proxy.
Configuring the source IPv6 address for MLD messages in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Configure the source IPv6
address for MLD general
queries.
4. Configure the source IPv6
address for MLD
multicast-address-specific
queries.
5. Configure the source IPv6
address for MLD reports.
6. Configure the source IPv6
address for MLD done
messages.
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip ipv6-address
mld-snooping special-query
source-ip ipv6-address
mld-snooping report
source-ip ipv6-address
mld-snooping done
source-ip ipv6-address
300
Remarks
N/A
N/A
By default, the source IPv6
address of MLD general queries is
the IPv6 link-local address of the
current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
address of MLD
multicast-address-specific
queries is one of the following:
•
The source address of MLD
general queries if the MLD
snooping querier of the
VLAN has received MLD
general queries.
•
The IPv6 link-local address
of the current VLAN interface
if the MLD snooping querier
does not receive an MLD
general query.
•
FE80::02FF:FFFF:FE00:000
1 if the MLD snooping
querier does not receive an
MLD general query and the
current VLAN interface does
not have an IPv6 link-local
address.
By default, the source IPv6
address of MLD reports is the
IPv6 link-local address of the
current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
address of MLD done messages
is the IPv6 link-local address of
the current VLAN interface. If the