Multicast Vpn Configuration Task List - HP FlexFabric 5950 series Configuration Manual

Hide thumbs Also See for FlexFabric 5950 series:
Table of Contents

Advertisement

Figure 81 M6VPE network
CE 1
VPN A
Site 1
IPv6 multicast traffic forwarding over the IPv4 public network is as follows:
1.
CE 1 forwards an IPv6 multicast packet for VPN instance VPN A to PE 1.
2.
PE 1 encapsulates the IPv6 multicast packet with an IPv4 packet header and transmits the IPv4
packet in the IPv4 backbone network.
3.
PE 2 decapsulates the IPv4 packet and forwards the IPv6 multicast packet to CE 2.

Multicast VPN configuration task list

Tasks at a glance
Configuring MD
(Required.)
(Required.)
(Required.)
(Required.)
(Required.)
(Optional.)
(Optional.)
(Optional.)
Configuring BGP
(Required.)
(Optional.)
The MTI interfaces are automatically created and bound with the VPN instance when you create an
MD for the VPN instance. Follow these guidelines to make sure the MTI interfaces are correctly
created.
The MTI interfaces take effect only after the default-group and the MD source interface are
specified and the MD source interface gets the public IP address.
To ensure correct MTI forwarding, create a service loopback group and specify the multicast
tunnel service by using the service-loopback group command. For more information about
this command, see Layer 2—LAN Switching Command Reference.
The PIM mode on the MTI must be the same as the PIM mode running on the VPN instance to
which the MTI belongs. When a minimum of one interface on the VPN instance is enabled with
PIM, the MTI is enabled with PIM accordingly. When all interfaces on the VPN instance are
PIM-disabled, PIM is also disabled on the MTI.
Public network
PE 1
VPN:
Enabling IP multicast routing for a VPN instance
Creating an MD for a VPN instance
Create an MD address family
Specifying the default-group
Specifying the MD source interface
Configuring MDT switchover parameters
Configuring the RPF vector feature
Enabling data-group reuse logging
MDT:
Configuring BGP MDT peers or peer groups
Configuring a BGP MDT route reflector
PE 2
P
219
CE 2
VPN A
Site 2

Advertisement

Table of Contents
loading

Table of Contents