Igmp Configuration Task List For Vsis - HP FlexFabric 5950 series Configuration Manual

Configuring the IGMP snooping
•
(Optional.)
•
(Optional.)
(Optional.) Enabling IGMP snooping proxying
Configuring parameters for IGMP
•
(Optional.)
•
(Optional.)
Configuring IGMP snooping
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)

IGMP configuration task list for VSIs

Tasks at a glance
Configuring basic IGMP snooping
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Configuring IGMP snooping port
(Optional.) Setting aging timers for dynamic ports
Configuring the IGMP snooping
•
(Optional.)
•
(Optional.)
Configuring parameters for IGMP
•
(Optional.)
•
(Optional.)
Configuring IGMP snooping
•
(Optional.)
•
(Optional.)
For IGMP reports received from secondary VLANs, the relevant IGMP snooping forwarding entries
are maintained by the primary VLAN. Therefore, you need to enable IGMP snooping only for the
primary VLAN. The IGMP snooping configuration made in secondary VLANs does not take effect.
For more information about primary VLANs and secondary VLANs, see Layer 2—LAN Switching
Configuration Guide.
The IGMP snooping configurations made on Layer 2 aggregate interfaces do not interfere with the
configurations made on member ports. In addition, the configurations made on Layer 2 aggregate
interfaces do not take part in aggregation calculations. The configuration made on a member port of
the aggregate group takes effect after the port leaves the aggregate group.
querier:
Enabling the IGMP snooping querier
Configuring parameters for IGMP general queries and responses
messages:
Configuring source IP addresses for IGMP messages
Setting the 802.1p priority for IGMP messages
policies:
Configuring a multicast group policy
Enabling multicast source port filtering
Enabling dropping unknown multicast data
Enabling IGMP report suppression
Setting the maximum number of multicast groups on a port
Enabling multicast group replacement
Enabling host tracking
features:
Enabling IGMP snooping
Specifying an IGMP snooping version
Setting the maximum number of IGMP snooping forwarding entries
Setting the IGMP last member query interval
features:
querier:
Enabling the IGMP snooping querier
Configuring parameters for IGMP general queries and responses
messages:
Configuring source IP addresses for IGMP messages
Setting the 802.1p priority for IGMP messages
policies:
Enabling dropping unknown multicast data
Enabling IGMP report suppression
18