Fujitsu PRIMERGY TX300 S4 Operating Manual page 77

Starting up and operation
Global Error
Does not light up when the system is OK. No service incident or critical
event has occurred.
Flashes red when a critical event has occurred. Details of the event can
be found in the BIOS Setup, in the System Event Log or using
ServerView S2. The indicator also flashes in standby mode.
Lights up red if a prefailure event was detected for a non-CSS
component. Details of the event can be found in the System Event Log
or using ServerView S2. The indicator also lights up in standby mode.
If the event is still acute after a power failure, the indicator is activated
after the restart.
ID
ID indicators on the front and rear of the server light up when the ID
button is pressed. The two ID indicators are synchronized.
Lights up blue when the system has been selected by pressing the ID
button. To deactivate, press the button again.
The ID indicator can also be activated via ServerView S2 and its status
reported to ServerView.
TX300 S4
Operating manual
Controls and indicators
77