Fujitsu PRIMERGY TX300 S4 Operating Manual page 12

Features
PCI SAS controller
To run the four SAS/SATA hard disk drives, the server is shipped with one of the
following two PCI SAS controllers:
– PCI SAS controller with "Integrated Mirroring Enhanced" (IME)
IME supports RAID level 0, 1 and 1E configuration of the internal hard disk
drives.
I
A separate utility is available to the controller for IME configuration.
Further information can be found in the "Integrated RAID for SAS
User's Guide" (on the ServerBooks DVD under "Controllers").
– PCI SAS controller with MegaRAID functionality
RAID levels 0, 1, 10, 5, 50, 6 and 60 are supported. If required, a BBU (=
battery backup unit) can save the memory content even if the power fails.
I
A separate utility is available to the controller for RAID configuration.
For further information, refer to the "SAS/SATA Controller MegaRAID
1064 / 1068 / 1078 Installation Guide" on the ServerBooks DVD
(select "Controllers" from the menu).
Accessible drives
The server has three 3.5-inch bays.
You can use these bays as follows:
– You can equip the individual bays with CD/DVD drives or magnetic tape
drives.
– In the bottom bay, you can install the Multibay 1 (FDD-DVD-LSD box). This
box has bays for a slimline floppy disk drive, a slimline DVD drive and the
ServerView Local Service Display.
– In the two lower bays, you can install the Multibay 2 (3.5' HDD-DVD-LSD
box). This box has bays for two additional 3.5-inch hard disk drives, a
slimline DVD drive and the ServerView Local Service Display.
– You can install the Multibay 1 (FDD-DVD-LSD box) in the bottom bay (see
above) and the expansion box for 2.5-inch SAS HDD modules in the two
upper bays (see also section
12
"Hard disk drives" on page
Operating manual
Preface
11).
TX300 S4