Fujitsu PRIMERGY TX300 S4 Operating Manual page 63

Hardware installation Installing/removing the rack model
The following steps can be carried out by one person only.
Figure 17: Telescope rail with safety spring
Ê Press in the safety springs (1) on both telescope rails.
Figure 18: Securing the server
Ê Slide the server into the rack.
Ê Fasten the server using four knurled screws.
Ê Route the cables once the server has been inserted, as described in the
Technical Manual for the classic rack.
To remove the server, follow this procedure in reverse.
Operating manual 63
TX300 S4