Fujitsu PRIMERGY TX300 S4 Operating Manual page 41

Hardware installation
Figure 2: Fitting the HDD cover
Ê Unlock the server (1) and remove the key (figure 2).
Ê Push the drive cover (2) up as far as it will go until it locks in place (about
0.5 cm above the closed position).
Ê Engage the guide pins on the left and right of the HDD cover in the
recesses (3) provided.
Ê Press the top end (4) of the HDD cover in the direction of the arrow until it
engages.
TX300 S4
Installing the floorstand model
Operating manual 41