Management Access On Stacks; Important Points To Remember - Dell S3048-ON Configuration Manual

Failover Count:
Last failover timestamp:
Last failover Reason:
Last failover type:
-- Last Data Block Sync Record:
------------------------------------------------
stack-unit Config:
Start-up Config:
Runtime Event Log:
Running Config:
ACL Mgr:
LACP:
STP:
SPAN:
Dell#

Management Access on Stacks

You can access the stack via the console port or VTY line.
• Console access — You may access the stack through the console port of the master unit (stack manager) only. Similar to a standby
RPM, the console port of the standby unit does not provide management capability; only a limited number of commands are available.
Member units provide a limited set of commands.
• Remote access — You may access the master unit and standby unit in a stack through the dedicated management Ethernet interfaces
with SNMP, SSH, or via Telnet.
Example of Accessing Non-Master Units on a Stack via the Console Port
-----------------CONSOLE ACCESS ON A STANDBY----------------------------
Dell(standby)#?
cd
clear
copy
delete
dir
disable
enable
exit
format
fsck
pwd
rename
reset
show
ssh-peer-stack-unit
start
telnet-peer-stack-unit
terminal
upload
Dell(standby)#
-----------------CONSOLE ACCESS ON A MEMBER----------------------------
Dell(stack-member-1)#?
reset-self Reset this unit alone
show Show running system information
You can connect two units with two or more stacking cables in case of a stacking port or cable failure. Removal of only one of the cables
does not trigger a reset.

Important Points to Remember

• You can stack up to six systems.
0
None
None
None
--
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
Change current directory
Reset functions
Copy from one file to another
Delete a file
List files on a filesystem
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Format a filesystem
Filesystem check utility
Display current working directory
Rename a file
Reset selected card
Show running system information
Open a SSH connection to the peer stack-unit
Start shell
Open a telnet connection to the peer stack-unit
Set terminal line parameters
Upload file
Stacking 805