Sample Configuration - Dell S3048-ON Configuration Manual

Hide thumbs Also See for S3048-ON:

Table of Contents

If you apply the redirect-list to an interface, the output of the show ip redirect-list redirect-list-

name command displays reachability status for the specified next-hop.

Example: Showing CAM PBR Configuration

Dell#show cam pbr stack-unit 1 port-set 0

TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN

Port VlanID Proto Tcp

---------------------------------------------------------------------------------------------

--------------------

199.199.199.199 N/A

00:00:00:00:00:09 8/1

Sample Configuration

You can use the following example configuration to set up a PBR. These are not comprehensive directions but are intended to give you a

guidance with typical configurations. You can copy and paste from these examples to your CLI. Make the necessary changes to support

your own IP addresses, interfaces, names, and so on.

The Redirect-List GOLD defined in this example creates the following rules:

description Route Gold traffic to the DS3

seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.1.0/24"

seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.2.0/24"

seq 15 permit ip any

0 0 200.200.200.200 200.200.200.200 199.199.199.199

40 234.234.234.234 255.234.234.234 222.222.222.222/24

Policy-based Routing (PBR)

Show Quick Links

Table of Contents