Table of Contents
Advertisement
The range of domain IDs is from 1 to 1000.
2
Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
3
Enter the VLAN ID number of the VLAN where the VLT forwards packets received on the VLTi from an adjacent peer that is down.
VLT DOMAIN CONFIGURATION mode
peer-down-vlan vlan interface number
Configuring Enhanced VLT (Optional)
To configure enhanced VLT (eVLT) between two VLT domains on your network, use the following procedure.
For a sample configuration, refer to
1
Configure the port channel to be used for the VLT interconnect on a VLT switch and enter interface configuration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number configured with the peer-link port-channel command in the
a VLT
Domain.
2
Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
•
For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
3
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
4
Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
5
Configure the IP address of the management interface on the remote VLT peer to be used as the endpoint of the VLT backup link for
sending out-of-band hello messages.
VLT DOMAIN CONFIGURATION mode
back-up destination ip-address [interval seconds]
You can optionally specify the time interval used to send hello messages. The range is from 1 to 5 seconds.
6
When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system MAC address used for internal
system operations. To explicitly configure the default MAC address for the domain by entering a new MAC address, use the following
command.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
eVLT Configuration
Example. To set up the VLT domain, use the following commands.
Enabling VLT and Creating
Virtual Link Trunking (VLT)
903
- Quick Links:
- Accessing the Command Line
- Cli Modes
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
