Configuring Ipv6 Ra Guard - Dell S3048-ON Configuration Manual

no ipv6 nd disable-reachable-timer
The following example shows how to disable the ND timer.
Dell(conf-if-fo-1/1/1)#ipv6 nd disable-reachable-timer

Configuring IPv6 RA Guard

The IPv6 Router Advertisement (RA) guard allows you to block or reject the unwanted router advertisement guard messages that arrive at
the network device platform.
To configure the IPv6 RA guard, perform the following steps:
1 Configure the terminal to enter the Global Configuration mode.
EXEC Privilege mode
configure terminal
2 Enable the IPv6 RA guard.
CONFIGURATION mode
ipv6 nd ra-guard enable
3 Create the policy.
POLICY LIST CONFIGURATION mode
ipv6 nd ra-guard policy policy-name
4 Define the role of the device attached to the port.
POLICY LIST CONFIGURATION mode
device-role {host | router}
Use the keyword host to set the device role as host.
Use the keyword router to set the device role as router.
5 Set the hop count limit.
POLICY LIST CONFIGURATION mode
hop-limit {maximum | minimum limit}
The hop limit range is from 0 to 254.
6 Set the managed address configuration flag.
POLICY LIST CONFIGURATION mode
managed-config-flag {on | off}
7 Enable verification of the sender IPv6 address in inspected messages from the authorized device source access list.
POLICY LIST CONFIGURATION mode
match ra{ipv6-access-list name | ipv6-prefix-list name | mac-access-list name}
8 Enable verification of the advertised other configuration parameter.
POLICY LIST CONFIGURATION mode
other-config-flag {on | off}
9 Enable verification of the advertised default router preference value. The preference value must be less than or equal to the specified
limit.
POLICY LIST CONFIGURATION mode
router-preference maximum {high | low | medium}
394 IPv6 Routing