Dell S3048-ON Configuration Manual page 729

Verify that the user role, myrole, has inherited the security administrator permissions. The output highlighted in bold indicates that the
user role has successfully inherited the security administrator permissions.
Dell(conf)#do show userroles
************* Mon Apr 28 14:46:25 PDT 2014 **************
Authorization Mode:
Role Inheritance
netoperator
netadmin
secadmin
sysadmin
myrole secadmin
Modifying Command Permissions for Roles
You can modify (add or delete) command permissions for newly created user roles and system defined roles using the role mode
{ { { addrole | deleterole } role-name } | reset } command command in Configuration mode.
NOTE: You cannot modify system administrator command permissions.
If you add or delete command permissions using the role command, those changes only apply to the specific user role. They do not apply
to other roles that have inheritance from that role. Authorization and accounting only apply to the roles specified in that configuration.
When you modify a command for a role, you specify the role, the mode, and whether you want to restrict access using the deleterole
keyword or grant access using the addrole keyword followed by the command you are controlling access.
The following output displays the modes available for the role command.
Dell (conf)#role ?
configure
exec
interface
line
route-map
router
Examples: Deny Network Administrator from Using the show users Command.
The following example denies the netadmin role from using the show users command and then verifies that netadmin cannot
access the show users command in exec mode. Note that the netadmin role is not listed in the Role access:
secadmin,sysadmin, which means the netadmin cannot access the show users command.
Dell(conf)#role exec deleterole netadmin show users
Dell#show role mode exec show users
Role access: secadmin,sysadmin
Example: Allow Security Administrator to Configure Spanning Tree
The following example allows the security administrator (secadmin) to configure the spanning tree protocol. Note command is protocol
spanning-tree.
Dell(conf)#role configure addrole secadmin protocol spanning-tree
Example: Allow Security Administrator to Access Interface Mode
role or privilege
Modes
Exec Config Interface Router IP Route-map Protocol MAC
Exec Config Line
Exec Config Interface Line Router IP Route-map Protocol MAC.
Exec Config Line
Global configuration mode
Exec Mode
Interface configuration mode
Line Configuration mode
Route map configuration mode
Router configuration mode
Security 729