Table of Contents
Advertisement
: Click to refresh the page; any changes made locally will be undone.
4.2.1.2 IP Configuration
The IP Configuration includes the IP Configuration, IP Interface and IP Routes. The configured column is
used to view or change the IP configuration. The maximum number of interfaces supported is 128 and the
maximum number of routes is 32.
The screen in
Figure 4-2-2
The current column is used to show the active IP configuration.
Object
IP Configurations
Mode
DNS Server
appears.
Figure 4-2-2: IP Configuration Page Screenshot
Description
Configure whether the IP stack should act as a Host or a Router. In Host
mode, IP traffic between interfaces will not be routed. In Router mode
traffic is routed between all interfaces.
This setting controls the DNS name resolution done by the switch.
There are four servers available for configuration, and the index of the
server presents the preference (less index has higher priority) in doing
DNS name resolution.
System selects the active DNS server from configuration in turn, if the
preferred server does not respond in five attempts.
The following modes are supported:
No DNS server
No DNS server will be used.
Configured IPv4
Explicitly provide the valid IPv4 unicast address of the
DNS Server in dotted decimal notation.
Make sure the configured DNS server could be
reachable (e.g. via PING) for activating DNS service.
57
User's Manual of IGS-6325 series
Advertisement
Table of Contents
