Mitsubishi MR-JE-10A Instruction Manual page 182

5. PARAMETERS
No./ Setting
symbol/name digit
PF23 Set a filter readjustment sensitivity of [Pr. PB13 Machine resonance suppression
filter 1] and [Pr. PB15 Machine resonance suppression filter 2] while the vibration
OSCL1
tough drive is enabled.
Vibration
However, setting "0" will be 50%.
tough drive -
Oscillation Example: When you set "50" to the parameter, the filter will be readjusted at the
detection time of 50% or more oscillation level.
level
Setting range: 0 to 100
PF24 _ _ _ x Oscillation detection alarm selection
*OSCL2 Select alarm or warning when an oscillation continues at a filter readjustment
sensitivity level of [Pr. PF23].
Vibration
tough drive The digit is continuously enabled regardless of the vibration tough drive in [Pr.
function PA20].
selection
0: [AL. 54 Oscillation detection] will occur at oscillation detection.
1: [AL. F3.1 Oscillation detection warning] will occur at oscillation detection.
2: Oscillation detection function disabled
_ _ x _ For manufacturer setting
_ x _ _
x _ _ _
PF25 Set the time of the [AL. 10.1 Voltage drop in the power] occurrence.
CVAT To disable the parameter, select "Disabled (_ 0 _ _)" of "Instantaneous power failure
tough drive selection" in [Pr. PA20].
instantaneous
power failure When "Enabled (_ 1 _ _)" is selected of "Instantaneous power failure tough drive
tough drive - selection" in [Pr. PA20], the power should be off for the setting value of this
detection time parameter + 1.5 s or more before cycling the power to enable a parameter whose
symbol is preceded by "*".
Setting range: 30 to 2000
PF31 Set a servo motor speed to divide a friction estimation area into high and low for the
friction estimation process of the machine diagnosis.
FRIC
However, setting "0" will be the value half of the rated speed.
Machine
diagnosis When your operation pattern is under rated speed, we recommend that you set half
function - value to the maximum speed with this.
Friction
judgement
speed
Forward rotation
direction
Servo motor
speed
Reverse rotation
direction
Setting range: 0 to
permissible speed
Function
Maximum speed in operation
0 r/min
Operation pattern
5 - 45
[Pr. PF31] setting
Initial Control mode
value
P S T
[unit]
50
[%]
0h
0h
0h
0h
200
[ms]
0
[r/min]