Furuno VR-7000 Instruction Manual page 32

2. SOFTWARE CONFIGURATION
Description of the items in the Setting window, VHF dialog box
[Active] : Put check in check box to make channel active.
[Brand] : Enter and display brand name.*
[Type No.] : Set type no. (equipment name)*
[Check] : Do equipment check.*
[Data Name] : Enter data name.*
[Input Type] : Enter input type.
[Sampling Data Bit] : Displays sampling data bit rate.
[Sampling Frequency] : Displays sampling frequency.
[Codec] : Set audio codec type.
[Delay Offset] : Enter amount of delay to apply to audio signal.
[Equipment Category] : Set equipment category.*
[Board Name] : Enter board names where channels are present.*
[Note]: Enter remarks. (Entry optional.)
* Enter these items for easy identification of equipment.
Description of the items in the Setting window, MIC dialog box
The [MIC] dialog box is similar to the [VHF] dialog box. Only the different items are
described below.
[MIC 1/3/5/7 Position] : Show the position odd-numbered MICs.
[MIC 2/4/6/8 Position] : Show the position of even-numbered MICs.
[Threshold Level MIC 1/3/5/7] : Show, set threshold level for odd-numbered MICs.
[Threshold Level MIC 2/4/6/8] : Show, set threshold level for even-numbered MICs.
2-16