Furuno VR-7000 Instruction Manual page 21

6. Enter the type no. (model no.) in the [Type No.] field.
7. Select the input type from the drop-down list in the [Input Type] field. The choices
are [VLC1], [VLC2], or [IEC61162-450]. Select [VLC] if the radar is connected via
the [VLC]; [IEC61162-450] for radar or ECDIS connected via LAN.
8. Do one of the following according to the selection made at step 5.
[VLC]: Enter channel number in the [Channel Number] field.
[IEC61162-450]: Enter the system function identifier in the [System Function ID]
field. Set the SFID of the radar/ECDIS input.
9. Enter the board name in the [Board] field.
10. Enter remarks in the [Note] field.
11. Click the [Check] button in the [Setting] window to confirm radar status, which is
then shown as [OK] or [NG] in the [Check] column in the [Information] window.
How to set up to record radar/ECDIS image
1. Click the [Image Record Setting] tab.
2. Select a radar channel from the [Information] window. For example, click the [CH
No.1] field to open the corresponding setup.
3. Check [Active] to make the radar (or ECDIS) active.
4. Select the recording method, [Only one] or [Patrol]. [Only one] records the source
having the youngest number in case of multiple sources. [Patrol] records all input
sources cyclically.
5. Select the input source for each of No. 1 to No. 4. The choices are [R1], [R2], [R3],
[R4], [E1], [E2], and [E3]. (R=Radar, E=ECDIS)
6. Select the compression type to use for the viewer, PNG or JPG.
7. Select the color bit to use. The choices are [6 bit], [9 bit], [12 bit], [15 bit], [18 bit],
[21 bit], and [24 bit].
8. Select [DRU Recording Limit Data Size]. Set the maximum amount of data to
record to the Fixed DRU.
9. Enter remarks in the [Note] field if required.
10. Click the [Set] button to finish.
2. SOFTWARE CONFIGURATION
2-5