Furuno VR-7000 Instruction Manual page 22

2. SOFTWARE CONFIGURATION
11. To record settings to the database, open the [Image Interface] tab, then click the
[Reflect Equipment] button in the [Setting] window.
12. Click the [Check] button in the [Setting] window to check the radar. The results
appear in the [Check] column of the [Information] window.
Recording scheme:
CH1
(DVI
or
RGB)
Radar
Config Management
After all items have been set, proceed to the final setting management. This can only
be executed one time, after all tabs have been set.
1. Click [VDR Config Management] in the [Maintenance] menu.
2. Click the [Upload] button to send all inputted data to the memory of the VDR.
3. Click the [Write] button to send data to the Fixed DRU, Float DRU, Long Term
Device, and CF.
Note: The settings must be uploaded to affect the configuration to the VDR.
4. The message "VDR will be rebooted. Continue?" appears click the [OK] button to
continue. You are then logged out of the Maintenance Viewer. The reboot takes
several minutes.
2-6
Radar1 Radar2
R1 R2 R3
VLC1 VLC2
CH2
(DVI
or
RGB)
Radar
ECDIS Additional
R4 E1 E2
IEC61162-450 IEC61162-450
LAN
ECDIS
E3
LAN
ECDIS