Furuno VR-7000 Instruction Manual page 28

2. SOFTWARE CONFIGURATION
5) Click the [Set] button.
6) Repeat steps 2) to 5) to set up other channels.
When using Config Manage with Tabs:
1. From the [Maintenance] menu, click [VDR Config Management].
2. Click the [Upload button] to save to the memory of the VDR.
3. Click the [Write] buttons to save to the Fixed DRU, Float DRU, Long Term Device,
and CF memory.
Description of the items in the Setting window
[CH Active Set] button: Click to show the [CH Active Setting] dialog box. Collective set-
ting is done from this box.
[Active] : Put check in check box to make channel active.
[Brand] : Enter brand name.*
[Type No.] : Set type no. (equipment name)
[Interface] ([JB] or [SA1-8]) : Type of Interface, Junction Box or Sensor Adapter.
[Check] : Do equipment check.
[Data Name] : Enter and display data name.*
[Contact Type] : Set contact type. [NO] : normal open, [NC] : normal close
[Sampling Rate] : Display sampling rate.
[Calibration Active] : Disable or enable digital calibration.
[Active Status (1)] : Set status display when (1) is active.*
[Active Status (0)] : Set status display when (0) is active.*
[Equipment Category] : Set equipment category.*
[Board Name] : Enter board names where channels are present.*
[Note]: Enter remarks. (Entry optional.)
* Enter these items for easy identification of equipment.
Note: Channels are assigned according to the presence or absence of Junction
Box(es), and the Junction Box total is set on the [System] tab.
2-12