Siemens Milltronics BW500 Operating Lnstructions page 150

P790 Hardware Error
The results of ongoing hardware tests in the communications circuitry.
Values
PASS
FAIL
ERR1
If FAIL or ERR1 is displayed in P790 (Hardware Error), go to P791 (Hardware Error Code)
and P792 (Hardware Error Count) for information about the error.
P791 Hardware Error Code
Indicates the precise cause of Fail or ERR1 condition from P790.
Values
0
Any other value
P792 Hardware Error Count
A count that increments by 1 each time Fail is reported in P790 (Hardware Error).
Values
Range: 0 to 9999
P794 SmartLinx Module Type
This parameter is used to identify the module type when SmartLinx is used. If you are not
using SmartLinx, this parameter is not functional. Please see the associated SmartLinx
instruction manual for a full description of this parameter.
P795 SmartLinx Protocol
This parameter is used to identify the protocol when SmartLinx is used. If you are not
using SmartLinx, this parameter is not functional. Please see the associated SmartLinx
instruction manual for a full description of this parameter.
If a SmartLinx module is not configured, P795 will have a value of either 255 or 0.
Page 144 Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS
Description
f
No errors
Error occurred communicating with card; device will try to reinitial-
ize communications with card. If message continues, record values
in P791 and P792 and contact your local Siemens representative.
No module installed, or module not supported; SmartLinx communi-
cations have been disabled
Description
f
No errors
Error code; provide this code to your Siemens representative for
troubleshooting
Description
Error count; provide this number to your Siemens representative for
troubleshooting.
7ML19985DK05