Siemens Milltronics BW500 Operating Lnstructions page 163

Software
Revision
3.00 April 27, 2001
3.01 July 17, 2001
3.02 August 07, 2001
3.03 February 20, 2002
3.04 May 09, 2002
3.05 November 11, 2002
7ML19985DK05Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS
Date
• Added flowmeter option
• Parameters are no longer changeable
with remote communications when
certification switch set
• Increased maximum idle time for
SmartLinx to 9999 seconds
• Fixed totalizer error when load is
negative and totalizer drop out is 0.00
• Allowed acces to P635 in certification
mode
• Setting of certification switch changes
totalizer dropout to 0.00
• Fixed bug in totalizer P619 totalizer
dropout
• Fixed timing issue with interval printing
• Added % rate and % load to PID
setpoint configuration, P414
• Updated Auto Zero to allow run display
to be seen, AZ now flashes in bottom
right hand corner of display
• Updated span adjust calculation
• Increased totalizer resolution to
100,000,000
• Improved error interruption on display
• Fixed zero and span calibration using
remote communications
• Fixed SmartLinx error checking
• Fixed error with discrete inputs
• Added P419 PID freeze enable/disable
• Updated zero calibration when
certification switch set, now references
last operator initiated zero prior
certification switch set
• Added power failure indicator on
display, "PF"
• Added online calibration
• SmartLinx memory map increased
• Improve external totalizer contact
closure duration
Changes
Page 157