Input Configuration ("Inp.cnf" And "Input") - Omega DP41-B Series User Manual

10. Data Format Commands (P, G, R, W)

10.2 INPUT CONFIGURATION ("INP.CNF" and "INPUt")

BIT POSITION
7 6 5 4
0
0
1
1
0
1
0
1
0
1
EXAMPLE: To set the meter with line frequency of 50 Hz, slow reading rate (in case of
MENU 2), degree K unit of measure, TC Cold-Junction enabled (in case of TC mode)
and input scale and offset enabled:
The command data is 01010001BIN. = 51 HEX. Then send *W0A51
TABLE 10.2 INPUT CONFIGURATION
INP.CNF and INPUt
3 2 1 0
0 60 Line Frequency 60Hz
1 50 Line Frequency 50Hz
0 SLOW (14/SEC) Reading Rate
1 FAST (100/SEC) Reading Rate
0 UNIPOL Voltage Unipolar; tC
1 BIPOL Voltage Bipolar
0 C Unit of Temperature Degree C
1 F Unit of Temperature Degree F
0 k Unit of Temperature Degree K
1 (Not Used)
tC.CO.JC ENAbLE TC Cold Junction;
3.LINR 3 wire linear RTD;
NORMAL Bridge Limit; Process (Not Used)
tC.CO.JC dISABL TC Cold Junction;
4.LINR 4 wire linear RTD ;
SP1.L2.H SP1 lower overload limit and SP2
upper overload limit; Process - (Not Used)
IN.SC.OF dISABL Input Scale & Offset
IN.SC.OF ENAbLE Input Scale & Offset
RAtIO dISABL Strain Non-Ratiometric;
TC & Process Default
RAtIO ENAbLE Strain Ratiometric
10-3