APRILIA MSS Mana GT ABS Service Station Manual page 256

Engine
- Grease the control bushing with suitable grease,
as shown in figure.
- Screw the control bushing to the complete mov-
able driving half-pulley. Push the bushing and
check that the bushing sliding axis and the slider
support engage by means of the two teeth.
- Once the gear checking is finished, unscrew the
driving pulley 1/2 of a turn.
CAUTION
MAKE SURE THERE IS A CORRECT GEAR BETWEEN THE
TOOTHED BUSHING AND THE SLIDER SUPPORT.
CAUTION
NO OTHER ELEMENT OF THE TRANSMISSION MUST BE
GREASED.
- Preassemble the belt on the rear pulley with a special tool.
Specific tooling
020659Y Tool to remove clutch and repl. belt
- Fit the unit following the removal steps but in reverse order with the specific tool being careful to tighten
to the prescribed torques.
ENG - 256
MSS Mana GT ABS