APRILIA MSS Mana GT ABS Service Station Manual page 120

Electrical system
AFTER ENTERING THE GEARSHIFT STROKE CATEGORY FROM THE "SETTINGS" MENU OF
THE DIAGNOSIS INSTRUMENT, YOU MUST PERFORM A KEY OFF/ON TO STORE THE DATA
ON THE CONTROL UNIT.
•
Check that the gearshift stroke category has been stored correctly from the "parameters"
menu of the diagnosis instrument.
•
Perform the belt replacement operation from the "parameters" menu of the diagnosis in-
strument.
•
To determine the gearshift class category, see the procedure in chapter "Motor - Automatic
transmission - Driving pulley fitting"
See also
Refitting the driving pulley
Driving pulley position sensor
SENSOR FITTING
Reset procedure
It is necessary to use Axone in case the variator unit is removed and the potentiometer is replaced or
removed: Potentiometer reset
CAUTION
FOR VEHICLES INCLUDED IN THE FOLLOWING RANGE
ZD4RC000_7S000002 - ZD4RC000_7S000737
IN ORDER TO FIT THE DRIVING PULLEY POSITION SENSOR CORRECTLY, SEE THE "Engine"
CHAPTER, "Transmission Cover Fitting" SECTION.
See also
Refitting the
transmission cover
Function
It tells the position of the driving half-pulley to the
transmission ECU.
Operation / Operating principle
It is a double track potentiometer, with inversely
proportional voltage variation.
Level in wiring diagram:transmission manage-
ment
Location:
•
on the vehicle: on the upper part of the
transmission cover.
•
connector: directly on the sensor.
Electrical characteristics:
ELE SYS - 120
MSS Mana GT ABS