Removing The Optional Sata Solid State Drive In A Qfx10000; Figure 149: Installing The Sata Ssd Into The Slot - Juniper QFX10016 Hardware Manual

Related
Documentation

Removing the Optional SATA Solid State Drive in a QFX10000

Copyright © 2017, Juniper Networks, Inc.

Figure 149: Installing the SATA SSD into the Slot

Tighten the two captive screws on the faceplate until hand-tight using the
5.
Phillips (+) screwdriver, number 1.
QFX10000 Optional Equipment on page 23
Removing the Optional SATA Solid State Drive in a QFX10000 on page 247
The QFX100000 allows optional installation of either a 50 GB or a 100 GB serial advanced
technology attachment (SATA) solid state drive (SSD) as a secondary boot drive or for
log storage. The SATA SSD is a hot-insertable and hot-removable field-replaceable unit
(FRU).
Before you remove an SATA SSD from the switch, ensure that you understand how to
prevent ESD damage. See
Ensure that you have the following parts and tools available to remove an SATA SSD
from a QFX10000:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
An electrostatic bag or antistatic mat
Chapter 21: Installing and Replacing an SSD
"Prevention of Electrostatic Discharge Damage" on page 327.
247