Figure 136: Adding Handle Extensions; Figure 137: Adding The Cable Tray - Juniper QFX10016 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 136: Adding Handle Extensions

Tighten the screws into the handle extensions.
4.
Snap open the blue clips on the ends of the cable tray with your hands.
5.
Place the cable tray across the front of the line card so that the two ends of the cable
6.
tray are under the handle extensions.
Snap to close the blue clips of the cable tray around the handle extensions (see
7.
Figure 137 on page 237).

Figure 137: Adding the Cable Tray

Drape and tie the optical cables to the side (see
8.
is to drape some of the cables under the handle extension and some cables over the
handle extension.
Chapter 19: Installing and Replacing Line Cards
Figure 138 on page 238). Another option
237