Step 4—Installing A T-Bar Clamp - Enterasys RoamAbout RBT-1602 Installation Manual

4. Install the 14.2‐mm (9/16‐inch) T‐bar clamp onto the ceiling T‐bar as shown in Figure
a. Slide each half of the clamp onto the T‐bar so that the clamp lip is fully on the T‐bar.
b. Slide the two halves of the clamp toward each other until the tabs are inserted completely
into the holes and the clamp fits snugly on the T‐bar.
Figure 2-3 Step 4—Installing a T-bar Clamp
5. Unlock the universal mounting bracket from the access point by inserting the 3‐mm or
1/8‐inch screwdriver into the Unlock hole on the access point as shown in Figure
Caution: To avoid damage to the access point's lock mechanism or electronic components, do
not use excessive force when inserting a tool into the Unlock or Lock hole.
Advertencia: para evitar daños en el mecanismo de cierre del punto de acceso o en los
componentes electrónicos, no introduzca con fuerza ninguna herramienta en el agujero de
"Unlock y Lock" (abrir y cerrar).
Achtung: Beim Einsatz eines Werkzeugs zum Öffnen bzw. Verschließen des Geräts sollten Sie
von übermäßigem Kraftaufwand absehen, da dies zu Beschädigungen des
Verriegelungsmechanismus oder elektronischer Komponenten führen kann.
Figure 2-4 Step 5—Unlocking the Bracket
T-bar
T-bar clamp halves
RBT-1602 and RBT-1602C Wireless Access Point Installation Guide 2-7
Installing the Access Point
Slide together
2‐3.
2‐4.