Appendix B: Technical Specifications; Ap Mechanical And Compliance Specifications - Enterasys RoamAbout RBT-1602 Installation Manual

This appendix lists the technical specifications for the Enterasys Networks RBT‐1602 and the
RBT‐1602C access points. Table B‐1 lists the mechanical and compliance specifications. Table
Table B‐3, and Table B‐4 list the radio specifications. Table
scheme.
Note: This Listed Accessory is designed and approved to be used only with Enterasys Networks
RoamAbout switch models. The RBT-8110, RBT-8210, and the RBT-8400 wireless switches do not
directly connect to the AP.
Note: The AP radios are disabled by default and can be enabled only by the system administrator
using the RASM management application or the switch's command-line interface (CLI).
Note: The radio frequency band, operating channels, and transmit power depend on the country of
operation specified by the system administrator using RASM or the switch's CLI.
Table B-1 AP Mechanical and Compliance Specifications
Specification
Size
Weight
Operating Temperature
Storage Temperature
Humidity
Power over Ethernet (PoE)
Status indicators
Wired network ports
Technical Specifications
Description
Diameter: 16.76 cm (6.6 inches)
Height: 4.69 cm (1.85 inches)
Without mounting bracket: 0.35 kg (12.5 ounces)
With mounting bracket: 0.40 kg (14 ounces)
0° C to +50° C (32° F to 122° F)
-20° C to +70° C (-4° F to +158° F)
10% to 95% noncondensing
42 VDC to 57 VDC (46 VDC nominal)
IEEE 802.3af
Health/switch and radio LEDs
(For descriptions of the LEDs, see
Two RJ-45 ports for 10/100BASE-T Ethernet and Power over Ethernet (PoE)
RBT-1602 and RBT-1602C Wireless Access Point Installation Guide B-1
B‐5 lists the MAC address allocation
"Status LEDs" on page 1-3.)
B
B‐2,