Table of Contents
Advertisement
Setting up your Computer
You must configure your computer to use the RoamAbout R1. This section describes how
to perform the following:
1.
Install the TCP/IP Protocol in your PC
2.
Determine how your ISP issues your IP Address
3.
Disable HTTP Proxy in your browser
4.
Obtain your IP settings
Installing the TCP/IP Protocol in your PC
If you do not have the TCP/IP Protocol installed on the client PC's you need to install it
and configure it to use the RoamAbout R1.This section describes how to install and
configure the TCP/IP Protocol.
Installation
Perform the following steps to install the TCP/IP Protocol on your PC:
1.
Click on Start and select Settings-->Control Panel.
2.
Double-click on the Network icon, and select the Configuration tab.
3.
Select the Protocol button and click on Add.
4.
Select Microsoft from the list of manufacturers, and TCP/IP from the list of Network
Protocols.
5.
Click on OK to complete the installation.
6.
Restart your computer.
Setting TCP/IP to Work with the RoamAbout R1
Perform the following steps to setup TCP/IP:
1.
Click on Start and select Settings-->Control Panel.
2.
Double-click on the Network icon, and select the Configuration tab.
3.
Select the TCP/IP line that was assigned to your network card.
4.
Click on the Properties button to set the TCP/IP Protocol to work with the
RoamAbout R1.
5.
You can dynamically assign TCP/IP address settings to a client (see
Allocation via a DHCP Server
address settings (see
Address is 192.168.2.1.
), or you can manually configure a client with
Manual IP Configuration
Dynamic IP
). The RoamAbout R1 default IP
3-3
Advertisement
Table of Contents
