Step 3—Placing The Bracket On The Junction Box - Enterasys RoamAbout RBT-1602 Installation Manual

3. Attach the universal mounting bracket to the junction box as shown in Figure
a. Place the universal mounting bracket against the junction box so that the two screw holes
face the junction box and align over the screw holes in the box.
b. Insert the #6‐32 x 1‐inch machine screws in the universal mounting bracket's screw holes,
and use a #2 Phillips‐head screwdriver to tighten them.
Figure 2-20 Step 3—Placing the Bracket on the Junction Box
4. Pull the Cat 5 cable(s) about 15 cm (about 6 inches) out of the junction box and through the
port connector opening to create enough slack to insert the cable(s) into the port connectors.
5. Insert the Cat 5 cable(s) into the connector(s):
– For a single connection, use the connector for port 1.
– For redundancy, insert one cable into each connector.
6. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock's cable around an object that cannot be moved or damaged by a
person pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the AP.
d. Rotate the key right or left to secure the lock to the AP.
e. Pull on the lock to verify that it is secured to the AP.
f. Remove the key.
7. Lift the access point into place on the universal mounting bracket.
Make sure the cable feeds properly into the junction box as you lift the device, and does not
become trapped between the access point and the bracket.
Junction box
RBT-1602 and RBT-1602C Wireless Access Point Installation Guide 2-17
Port connector
opening
Installing the Access Point
2‐20: