Step 6—Removing The Bracket - Enterasys RoamAbout RBT-1602 Installation Manual

Installing the Access Point
6. Remove the bracket as shown in Figure
Figure 2-5
7. Install the universal mounting bracket as follows onto the T‐bar or T‐bar clamp:
a.
Figure 2-6
b. Properly align the bracket for mounting by placing the bracket so that its port connector
c.
2-8 Installing and Connecting the Access Point
Step 6—Removing the Bracket
As shown in Figure 2‐6, place the universal mounting bracket against the T‐bar or clamp
so that the two screw holes face downward and the two T‐bar flanges face upward and are
adjacent to the T‐bar edges.
Step 7—Top View
Universal mounting
bracket
T-bar
Port connector
opening
(Viewed from above ceiling tiles, looking down.)
opening is to the left of the hole you cut for the cables.
Rotate the universal mounting bracket clockwise until the flanges snap into place on the
T‐bar or clamp as shown in Figure
2‐5.
2‐7.