Configuring The Fspf Cost For An Interface; Configuring The Hello Interval For An Interface - HP 5920 SERIES Fc And Fcoe Configuration Manual

Step
2. Enter VSAN view.
3. Configure the minimum
LSR refresh interval.

Configuring the FSPF cost for an interface

Each link has a cost. The route selection algorithm uses this value to determine the best route. The smaller
the interface FSPF cost, the smaller the link cost.
To configure the FSPF cost for an interface:
Step
1. Enter system view.
2. Enter FC interface, FC
aggregate interface, or
VFC interface view.
3. Configure the FSPF cost
for the interface in a
specific VSAN.

Configuring the hello interval for an interface

The hello interval specifies the time between the hello packets sent periodically by the switch to discover
and maintain neighbor relationships.
NOTE:
The configured hello interval must be smaller than the dead interval and must be the same at the two ends
of the link.
To configure the hello interval for an interface:
Step
1. Enter system view.
2. Enter FC interface, FC
aggregate interface, or VFC
interface view.
3. Configure the hello interval for
the interface in a specific VSAN.
Command
vsan vsan-id
fspf min-ls-interval value
Command
system-view
interface { fc | vfc |
san-aggregation }
interface-number
fspf cost value vsan vsan-id
Command
system-view
interface { fc | vfc |
san-aggregation }
interface-number
fspf hello-interval value vsan
vsan-id
76
Remarks
N/A
The default setting is 5 seconds.
Remarks
N/A
N/A
The default setting of FC interfaces is
calculated by using the following formula:
1.0*1.062e12/baud rate.
The default setting for VFC interfaces and FC
aggregate interfaces are 100.
Remarks
N/A
N/A
The default setting is 20 seconds.