Requirements Analysis - HP 5920 SERIES Fc And Fcoe Configuration Manual
Hide thumbs
Also See for 5920 SERIES:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fundamentals configuration manual (215 pages)
Table of Contents
Advertisement
Figure 49 Network diagram
Requirements analysis
To meet the network requirements, perform the following tasks:
To transmit the storage traffic over lossless Ethernet links in the SANs, HP recommends that you
•
perform the following tasks:
Configure DCBX, PFC in auto mode, and ETS on the Ethernet interfaces connecting the switches
to the server.
Enable PFC by force on the Ethernet interfaces connecting switches.
•
To implement link backup between the server and the disk device, use two separate SANs to
provide connections between the server and the disk device. The two SANs can use the same
VSAN. The two separate VSANs are as follows:
One physical SAN is formed by the server, Switch A, Switch C, and the disk device.
The other physical SAN is formed by the server, Switch B, Switch D, and the disk device.
To transmit the Ethernet traffic of the LAN in VLAN 1001, configure the following interfaces to allow
•
VLAN 1001:
The Ethernet interfaces connecting Switch A and Switch B to the LAN.
The Ethernet interfaces connecting Switch A and Switch B to the server.
199
Advertisement
Table of Contents
