HP 5920 SERIES Fc And Fcoe Configuration Manual page 75

[SwitchC] vsan 1
[SwitchC-vsan1] domain configure enable
# Configure the domain ID as 13 in VSAN 1.
[SwitchC-vsan1] domain-id 13 preferred
Non-disruptive reconfiguration or isolating the switch may be performed. Continue?
[Y/N]:y
4. Configure Switch D:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchD> system-view
[SwitchD] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchD] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchD] quit
# Reboot the switch.
<SwitchD> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
<SwitchD> system-view
[SwitchD] fcoe-mode fcf
# Enable the fabric configuration feature in VSAN 1. By default, the fabric configuration feature is
enabled.
[SwitchD] vsan 1
[SwitchD-vsan1] domain configure enable
# Configure the domain ID as 14 in VSAN 1.
[SwitchD-vsan1] domain-id 14 preferred
Non-disruptive reconfiguration or isolating the switch may be performed. Continue?
[Y/N]:y
Verifying the configuration
1. Verify the configuration on Switch A:
# Display the domain information of VSAN 1.
[SwitchA-vsan1] display fc domain vsan 1
Domain Information of VSAN 1:
Running time information:
68