Fcoe Configuration Example By Using Vfc Interfaces (In Irf Mode); Network Requirements - HP 5920 SERIES Fc And Fcoe Configuration Manual

Destinations : 5
Destination/mask
0x010000/8
0xfffc01/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
The output shows that an FSPF route from Switch A to Switch C exists, with the outgoing interface VFC 10.
# Display the node login information for VSAN 100.
[SwitchA] display fc login vsan 100
Interface VSAN FCID
Vfc1
# Display the brief information about the name server database in VSAN 100.
[SwitchA] display fc name-service database vsan 100
VSAN 100:
FCID
0x010000 0x01(N)
0x020000 0x01(N)
Verifying the configuration on Switch C and Switch D
Verify the configuration on Switch C and Switch D, for example, Switch C.
# Display the node login information for VSAN 100.
[SwitchC] display fc login vsan 100
Interface VSAN FCID
Vfc1
FCoE configuration example by using VFC
interfaces (in IRF mode)

Network requirements

As shown in
Switch A and Switch B are connected to an Ethernet switch, and operate at the access layer of the
•
LAN.
Switch A and Switch B are connected to Switch C and Switch D, respectively.
•
• The four switches operate as the FCF switches of the SANs.
Configure FCoE to meet the following requirements:
• The transmission network formed by Switch A, Switch B, and the Ethernet switch can use the server
to provide services for the LAN. The transmission network formed by switches A through D can
enable the server to access the disk device.
Link backup is used to implement high availability for the packets to and from the server and disk
•
device.
Routes : 5
Protocol
FSPF
DIRECT
DIRECT
DIRECT
DIRECT
Node WWN
100 0x020000 21:01:00:1b:32:a0:fa:12 21:01:00:1b:32:a0:fa:11
Type
Node WWN
100 0x010000 10:00:00:05:30:00:25:a4 10:00:00:05:30:00:25:a3
Figure 48:
Preference Cost
20 100
0 0
0 0
0 0
0 0
Port WWN
PWWN(vendor)
10:00:00:05:30:00:25:a3
21:01:00:1b:32:a0:fa:11
Port WWN
180
Interface
Vfc10
InLoop0
InLoop0
InLoop0
InLoop0
FC4-type:feature
SCSI-FCP:Target
SCSI-FCP:Initiator