Configuration Procedure; Configuring Fspf; Fspf Configuration Task List; Enabling Fspf - HP 5920 SERIES Fc And Fcoe Configuration Manual

Configuration procedure

To configure a static FC route:
Step
1. Enter system view.
2. Enter VSAN view.
3. Configure a static FC
route.

Configuring FSPF

FSPF is enabled by default. Typically, you do not need to perform special operations.
You can change FSPF parameters on a per-VSAN or per-interface basis.

FSPF configuration task list

Tasks at a glance
Change FSPF parameters for a VSAN in VSAN view
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.) Change FSPF parameters for an interface in E_Port interface view
•
Configuring the FSPF cost for an interface
•
Configuring the hello interval for an interface
•
Configuring the dead interval for an interface
•
Configuring the LSR retransmission interval for an interface
•
Disabling FSPF for an interface
(Optional.)
•
Configuring the GR restarter
•
Configuring the GR helper

Enabling FSPF

FSPF-related features can work in a VSAN only after you enable FSPF for the VSAN.
To enable FSPF:
Step
1. Enter system view.
Command
system-view
vsan vsan-id
fc route-static fcid { mask | mask-length }
interface-type interface-number [ cost
cost-value ]
Enabling FSPF
Configuring the shortest SPF calculation interval
Configuring the minimum LSR arrival interval
Configuring the minimum LSR refresh interval
Configuring FSPF GR
Command
system-view
Remarks
N/A
74
Remarks
N/A
N/A
By default, no static FC route exists.