Configuring Common Console User Interface Settings (Optional) - HP MSR Series Configuration Manual

The next time you attempt to log in through the console port, you must provide the configured login
username and password, as shown in
Figure 11 Scheme authentication interface for console login

Configuring common console user interface settings (optional)

Some common settings configured for a console user interface take effect immediately and can interrupt
the console login session. To save you the trouble of repeated re-logins, use a login method different from
console login to log in to the device before you change console user interface settings.
After the configuration is complete, change the terminal settings on the configuration terminal and make
sure they are the same as the settings on the device.
To configure common settings for a console user interface:
Step
1. Enter system view.
2. Enter console user interface
view.
3. Set the baud rate.
4. Specify the parity check
mode.
5. Specify the number of stop
bits.
Figure 1 1.
Command
system-view
user-interface console first-number
[ last-number ]
speed speed-value
parity { even | mark | none | odd
| space }
stopbits { 1 | 1.5 | 2 }
31
Remarks
N/A
N/A
By default, the baud rate is 9600
bps.
The default setting is none, namely,
no parity check.
The default is 1.
Stop bits indicate the end of a
character. The more the stop bits, the
slower the transmission.