HP 5920 SERIES Fc And Fcoe Configuration Manual page 90

[SwitchC] interface ten-gigabitethernet 1/0/2
[SwitchC-Ten-GigabitEthernet1/0/2] port-type fc
# Configure the mode of interface FC 1/0/2 as E.
[SwitchC-Fc1/0/2] fc mode e
# Configure interface FC 1/0/2 to autonegotiate the speed.
[SwitchC-Fc1/0/2] speed auto
# Configure the trunk mode of interface FC 1/0/2 as On, and assign interface FC 1/0/2 to
VSAN 1 as a trunk port.
[SwitchC-Fc1/0/2] port trunk mode on
[SwitchC-Fc1/0/2] port trunk vsan 1
[SwitchC-Fc1/0/2] quit
# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.
[SwitchC] vlan 10
[SwitchC-vlan10] fcoe enable vsan 1
[SwitchC-vlan10] quit
# Configure two static routes in VSAN 1.
[SwitchC] vsan 1
[SwitchC-vsan1] fc route-static 010000 8 fc 1/0/2
[SwitchC-vsan1] fc route-static 020000 8 fc 1/0/2
Verifying the configuration
# Display the FC routing table in VSAN 1 on Switch A.
[SwitchA-vsan1] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x020000/8
0x030000/8
0xfffc01/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
# Display the FC routing table in VSAN 1 on Switch B.
[SwitchB-vsan1] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x010000/8
0x030000/8
0xfffc02/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
# Display the FC routing table in VSAN 1 on Switch C.
[SwitchC-vsan1] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Routes : 6
Protocol Preference
STATIC 10
STATIC 10
DIRECT 0
DIRECT 0
DIRECT 0
DIRECT 0
Routes : 6
Protocol Preference
STATIC 10
STATIC 10
DIRECT 0
DIRECT 0
DIRECT 0
DIRECT 0
Routes : 6
83
Cost Interface
0 Fc1/0/1
0 Fc1/0/1
0 InLoop0
0 InLoop0
0 InLoop0
0 InLoop0
Cost Interface
0 Fc1/0/1
0 Fc1/0/2
0 InLoop0
0 InLoop0
0 InLoop0
0 InLoop0