Fc Link Aggregation Configuration Example; Network Requirements; Configuration Procedure - HP 5920 SERIES Fc And Fcoe Configuration Manual

Task
Display FC aggregate interface
information.
Clear the statistics of an FC
aggregate interface.

FC link aggregation configuration example

Network requirements

To increase bandwidth and enhance connection reliability between FCF switches Switch A and Switch B,
create an FC aggregate link between Switch A and Switch B.
Figure 17 Network diagram

Configuration procedure

This section describes only the FC link aggregation-related configurations, and does not provide the
procedure for the other configurations.
1. Configure Switch A:
IMPORTANT:
After you assign the FC interfaces at both ends to the FC aggregation group, use the undo shutdown
command to bring up the member FC interfaces.
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
Command
display interface [ san-aggregation ] [ brief [ down ] ]
display interface [ san-aggregation [ interface-number ] ] [ brief
[ description ]
reset counters interface [ san-aggregation [ interface-number ] ]
25