HP 5920 SERIES Fc And Fcoe Configuration Manual page 193

Hide thumbs Also See for 5920 SERIES:
Table of Contents

Advertisement

[SwitchA-Bridge-Aggregation3] stp enable
# Enable LACP MAD for Layer 2 aggregate interface 3.
[SwitchA-Bridge-Aggregation3] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 1]:
The assigned
Info: MAD LACP only enable on dynamic aggregation interface.
[SwitchA-Bridge-Aggregation3] quit
# Assign ports Ten-GigabitEthernet 1/0/10 and Ten-GigabitEthernet 2/0/10 to Layer 2
aggregation group 3.
[SwitchA] interface ten-gigabitethernet 1/0/10
[SwitchA-Ten-GigabitEthernet1/0/10] port link-aggregation group 3
[SwitchA-Ten-GigabitEthernet1/0/10] quit
[SwitchA] interface ten-gigabitethernet 2/0/10
[SwitchA-Ten-GigabitEthernet2/0/10] port link-aggregation group 3
[SwitchA-Ten-GigabitEthernet2/0/10] quit
# Configure Layer 2 aggregate interface 3 as a trunk port, and assign the aggregate interface to
VLAN 1001.
[SwitchA] interface bridge-aggregation 3
[SwitchA-Bridge-Aggregation3] port link-type trunk
[SwitchA-Bridge-Aggregation3] port trunk permit vlan 1001
[SwitchA-Bridge-Aggregation3] quit
3.
Configure DCBX:
# Enable LLDP globally.
[SwitchA] lldp global enable
# Create Ethernet frame header ACL 4000.
[SwitchA] acl number 4000 name DCBX
# Configure the ACL to permit FCoE frames (protocol number is 0x8906) to pass through.
[SwitchA-acl-ethernetframe-4000] rule 0 permit type 8906 ffff
# Configure the ACL to permit FIP protocol packets (protocol number is 0x8914) to pass through.
[SwitchA-acl-ethernetframe-4000] rule 5 permit type 8914 ffff
[SwitchA-acl-ethernetframe-4000] quit
# Create a class named DCBX, with the operator of the class as OR.
[SwitchA] traffic classifier DCBX operator or
# Use ACL 4000 as the match criterion of the class.
[SwitchA-classifier-DCBX] if-match acl 4000
[SwitchA-classifier-DCBX] quit
# Create a behavior named DCBX.
[SwitchA] traffic behavior DCBX
# Configure the behavior to mark packets with 802.1p priority value 3.
[SwitchA-behavior-DCBX] remark dot1p 3
[SwitchA-behavior-DCBX] quit
# Create a QoS policy named DCBX.
[SwitchA] qos policy DCBX
domain ID is: 1
186

Advertisement

Table of Contents
loading

This manual is also suitable for:

5900 series

Table of Contents