Checking The Frame; Checking The Swingarm; Checking The Throttle Cable Routing - Husqvarna TC 65 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.41

Checking the frame

11.42

Checking the swingarm

11.43

Checking the throttle cable routing

Warning
Danger of accidents The throttle cable may slip out of the guide if routed incorrectly.
The throttle slide will then no longer be closed and the speed can no longer be controlled.
–
Make sure that the throttle cable routing and the play in throttle cable complies with the specification.
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
E00568-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
601599-01
–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm.
V00216-01
Preparatory work
–
Remove the seat. (
–
Remove the right side cover. (
–
Remove the left side cover. (
–
Turn the knurled screw on the fuel tap all the way clockwise.
–
Remove the fuel tank.
Main work
–
Check the throttle cable routing.
The throttle cable must be routed behind the handlebar, behind the coolant
hose and left on the frame.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
E00567-01
Info
Always replace a frame that has been damaged due to a mechan-
ical impact. Repair of the frame is not authorized by Husqvarna
Motorcycles.
Info
Always change a damaged swingarm. Repair of the swingarm is
not authorized by Husqvarna Motorcycles.
p. 44)
p. 39)
p. 41)
( p. 47)
M6 10 Nm
(7.4 lbf ft)
p. 31)
53