Husqvarna TC 65 Owner's Manual page 54

11 SERVICE WORK ON THE CHASSIS
–
Check the engine sprocket cover for wear.
»
If the engine sprocket cover is worn through in the marked area
–
Change the engine sprocket cover.
–
Check the engine sprocket cover for tightness.
» If the engine sprocket cover is loose:
–
Tighten the engine sprocket cover.
Guideline
Screw, engine sprocket cover
S01525-10
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
E00570-10
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Remaining screws, chassis
E00569-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01

:
M6 10 Nm
(7.4 lbf ft)
M8 25 Nm
(18.4 lbf ft)
52