Removing The Rear Wheel - Husqvarna TC 65 Owner's Manual

13 WHEELS, TIRES
13.3

Removing the rear wheel

–
Clean and grease wheel spindle
Long-life grease (
–
Position the front wheel.
The brake linings are correctly positioned.
–
Insert wheel spindle.
–
Tighten screws
Guideline
E00545-10
Screw, fork stub
–
Mount and tighten screw
Guideline
Screw, front wheel spin-
dle
–
Loosen screws
–
Remove the motorcycle from the lift stand. (
E00547-11
–
Operate the hand brake lever several times until the brake linings are seated cor-
rectly against the brake disc.
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
E00546-10
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove nut
–
Remove chain adjuster
E00544-11
–
Withdraw wheel spindle
forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
Info
Cover the components to protect them against damage.
Warning
E00543-11
Danger of accidents Damaged brake discs reduce the braking effect.
–
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of
the swingarm.
Info
Do not operate the foot brake lever when the rear wheel is removed.

.
p. 92)

.

.
M10

.

.

.

.

only enough to allow the rear wheel to be pushed
Always lay the wheel down in such a way that the brake disc is not
damaged.
M6 10 Nm (7.4 lbf ft)
40 Nm Loctite
(29.5 lbf ft)
p. 31)
M6 10 Nm (7.4 lbf ft)
p. 31)
68
® 243™