Husqvarna TC 65 Owner's Manual page 58

11 SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
E00564-11
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
On the slave cylinder, remove the bleeder screw and mount bleeding syringe
E00563-10
–
Now inject the fluid into the system until it emerges from drill hole
ter cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
E00562-10
Info
Clean up overflowed or spilled brake fluid immediately with water.

.
 
with membrane .

with the appropriate hydraulic fluid.
p. 90)

4 mm (0.16 in)
56

.
of the mas-