Stihl MS 200 Service Manual page 83

3
2
1
: Pull the tank vent hose (1) and
the fuel hose (2) out of the handle
housing.
: Disconnect the impulse hose (3).
– Remove the handle housing,
check and replace if necessary
– Check the wiring harness and
contact spring and replace if
necessary. b 9.5.4
– Check the interlock lever and
throttle trigger and replace if
necessary, b 12.2
– Check the choke and throttle rods
and replace if necessary,
b 12.3.1
– Check the switch shaft and
replace if necessary, b 12.1.1
1
: Pull the cover (1) out of the
handle housing.
– Inspect the cover and replace if
necessary,
82
2
: Push on the cover (1). The pegs
must engage the holes and the
lug (2) the opening.
1
: Pull the pegs (arrows) into the
holes and make sure they are
properly seated.
– The cover's lug (1) must
completely fill the opening – it
secures the contact spring in
position.
1
1
: Take out the screw (arrow).
– Pull out the handlebar (1), check
it and replace if necessary.
– Reassemble in the reverse
sequence.
: Take out the screw (arrow).
– Pull out the shutter (1) for
summer/winter operation, check
it and replace if necessary.
– Reassemble in the reverse
sequence.
MS 200, MS 200 T
1